Albatros D.I
Albatros D.I | |
---|---|
Role | Fighter |
Manufacturer | Albatros Flugzeugwerke |
Designer | Robert Thelen |
Introduction | August 1916 |
Primary user | Luftstreitkräfte |
Number built | 50 |
|
The Albatros D.I was a German fighter aircraft used during World War I. Although its operational career was short, it was the first of the Albatros D types which equipped the bulk of the German and Austrian fighter squadrons (Jagdstaffeln) for the last two years of the war.
Design and development
The D.I was designed by Robert Thelen, R. Schubert and Gnädig, as an answer to the latest Allied fighters, such as the Nieuport 11 Bébé and the Airco D.H.2, which had proved superior to the Fokker Eindecker and other early German fighters, and established a general Allied air superiority. It was ordered in June 1916 and introduced into squadron service that August.[1]
The D.I had a semi-monocoque plywood fuselage, consisting of a single-layered outer shell, supported by a minimal internal structure. This was lighter and stronger than the fabric-skinned box-type fuselage then in common use, as well being easier to give an aerodynamically clean shape. At the same time its panelled-plywood skinning, done with mostly four-sided panels of thin plywood over the entire minimal fuselage structure, was less labour-intensive (and therefore less costly to manufacture) than a "true" monocoque structure.[2] The Albatros D.I was powered by either a 110 kW (150 hp) Benz Bz.III or a 120 kW (160 hp) Mercedes D.III six-cylinder water cooled inline engine. The additional power of the Mercedes (Daimler) engine enabled twin fixed Spandau machine-guns to be fitted without any loss in performance.[2]
The D.I had a relatively high wing loading for its time, and was not particularly manoeuvrable. This was compensated by its superior speed and firepower and it quickly proved the best all-round fighter available.[2]
Operational history
A total of 50 pre-series and series D.I aircraft were in service by November 1916, replacing the early Fokker and Halberstadt D types, giving real "teeth" to the Luftstreitkräfte's new Jagdstaffeln (fighter squadrons). Further production of D.Is was not undertaken, however; instead, a reduction in the gap between the upper and lower wing in order to improve the pilot's forward and upward vision resulted in the otherwise identical Albatros D.II,which became Albatros' first major production fighter.[1]
Operators
Specifications (D.I with Benz engine)
Data from German Combat Planes: A Comprehensive Survey and History of the Development of German Military Aircraft from 1914 to 1945[3]
General characteristics
- Crew: 1
- Length: 24 ft 3 in (7.4 m)
- Wingspan: 27 ft 11 in (8.5 m)
- Height: 9 ft 8 in (2.95 m)
- Wing area: 246 sq ft (22.9 m2)
- Empty weight: 1,426 lb (647 kg)
- Gross weight: 1,980 lb (898 kg)
- Powerplant: 1 × Benz Bz.III 6-cyl. water-cooled in-line pistonengine, 150 hp (110 kW)
- Propellers: 2-bladed wooden fixed pitch
Performance
- Maximum speed: 109 mph; 94 kn (175 km/h)
- Endurance: 1.5
- Service ceiling: 16,404 ft (5,000 m)
- Rate of climb: 550 ft/min (2.8 m/s)
Armament
- Guns: 1 × forward-firing synchronized 7.92 mm (0.312 in) lMG 08 machine gun
See also
- Related development
- Aircraft of comparable role, configuration and era
References
Wikimedia Commons has media related to Albatros D.I. |
Notes
Bibliography
- Cheesman, E.F. Fighter Aircraft of the 1914-1918 War. London: Harleyford Publications, 1960.
- Gray, Peter and Owen Thetford. German Aircraft of the First World War (2nd ed.). London: Putnam, 1970. ISBN 978-0-370-00103-6.
- Munson, Kenneth. Fighters, Attack and Training Aircraft 1914-1919 War. London: Blandford Press, 1968.
- Taylor, John W.R. Combat Aircraft of the World from 1909 to the Present. New York: G.P. Putnam's Sons, 1969. ISBN 0-425-03633-2.
- Wagner, Ray and Heinz J. Nowarra. German Combat Planes: A Comprehensive Survey and History of the Development of German Military Aircraft from 1914 to 1945. Garden City, New York: Doubleday, 1971.