Uranium tailings
Uranium tailings are a waste byproduct (tailings) of uranium mining. In mining, raw uranium ore is brought to the surface and crushed into a fine sand. The valuable uranium-bearing minerals are then removed via heap leaching with the use of acids or bases, and the remaining radioactive sludge, called "uranium tailings", is stored in huge impoundments. A short ton (907 kg) of ore yield one to five pounds (0.45 to 2.3 kg) of uranium depending on the uranium content of the mineral.[1] Uranium tailings can retain up to 85% of the ore's original radioactivity.[2]
If uranium tailings are stored aboveground and allowed to dry out, the radioactive sand can be carried great distances by the wind, entering the food chain and bodies of water. The danger posed by such sand dispersal is uncertain at best given the dilution effect of dispersal. The majority of tailing mass will be inert rock, just as it was in the raw ore before the extraction of the uranium, but physically altered, ground up, mixed with large amounts of water and exposed to atmospheric oxygen, which can substantially alter chemical behaviour.
Uranium tailings contain over a dozen radioactive nuclides, which are the primary hazard posed by the tailings. The most important of these are thorium-230, radium-226, radon-222 (radon gas) and the daughter isotopes of radon decay, including polonium-210.
An EPA estimate of risk based on uranium tailings deposits existing in the United States in 1983 gave the figure of 500 lung cancer deaths per century if no countermeasures are taken.[3]
See also
References
- ↑ Grammer, Elisa J. (1981), "The Uranium Mill Tailings Radiation Control Act of 1978 and NRC's Agreement State Program", Natural Resources Lawyer, 13 (3): 469–522, JSTOR 40922651
- ↑ Robinson, Paul; Hector, Alice; Luis, Judy; Benavides, David; Hancock, Don (1979), "Uranium Mining and Milling: A Primer" (PDF), The Workbook, Albuquerque, New Mexico: Southwest Research & Information Center, 4 (6-7), retrieved December 9, 2012
- ↑ Peter Diehl. "Uranium Mining and Milling Wastes: An Introduction". Retrieved 2009-10-02.