Epoxidized soybean oil

Epoxidized soybean oil
Names
Other names
ESBO; Epoxidized soya bean oil; ESO
Identifiers
8013-07-8 N
ECHA InfoCard 100.029.444
Properties
Appearance Light yellow viscous liquid[1]
Density 0.994 g/cm3[1]
Melting point 0 °C (32 °F; 273 K)[1]
Insoluble[1]
Hazards
R-phrases R36 R37 R38 R43
S-phrases S24 S26 S37
NFPA 704
Flammability code 1: Must be pre-heated before ignition can occur. Flash point over 93 °C (200 °F). E.g., canola oil Health code 1: Exposure would cause irritation but only minor residual injury. E.g., turpentine Reactivity code 0: Normally stable, even under fire exposure conditions, and is not reactive with water. E.g., liquid nitrogen Special hazards (white): no codeNFPA 704 four-colored diamond
1
1
0
Flash point 227 °C (441 °F; 500 K)
600
Except where otherwise noted, data are given for materials in their standard state (at 25 °C [77 °F], 100 kPa).
N verify (what is YesYN ?)
Infobox references

Epoxidized soybean oil (ESBO) is a collection of organic compounds obtained from the epoxidation of soybean oil. It is used as a plasticizer and stabilizer in polyvinyl chloride (PVC) plastics. ESBO is an yellowish viscous liquid.[2]

Manufacturing process

Epoxidized linolein, a major component of ESBO.

ESBO is manufactured from soybean oil through the process of epoxidation. Polyunsaturated vegetable oils are widely used as precursors to epoxidized oil products because they have high numbers of carbon-carbon double bonds available for epoxidation.[3] The epoxide group is more reactive than double bond, thus providing a more energetically favorable site for reaction and making the oil a good hydrochloric acid scavenger and plasticizer. Usually a peroxide or a peracid is used to add an atom of oxygen and convert the -C=C- bond to an epoxide group.[2]

Uses

Food products that are stored in glass jars are usually sealed with gaskets made from PVC. ESBO is one of the additives in the PVC gasket. It serves as a plasticizer and a scavenger for hydrochloric acid released when the PVC degrades thermally, e.g. when the food product undergoes sterilization.[4]

Safety

Food

A Swiss survey in June 2005 showed that migration of ESBO into foods could reach up to 1,170 mg/kg.[5] Rapid Alert System in Food and Feed (RASFF) had also reported cases of food product rejection in EU for exceeding SML under EU Legislation (EC/2002/72).[6]

Legislation

In Europe, plastics are regulated by the Commission Directive 2002/72/EC which consolidates Commission Directive 90/128/EEC and its seven amendments (Directives 92/39/EEC, 93/9/EEC, 95/3/EEC, 96/11/EEC, 1999/91/EC, 2001/62/EC and 2002/17/EC). These amendments mainly modified the lists of authorized substances such as monomers and additives.

Directive 2002/72/EC establishes a specific migration limit for ESBO of 60 mg/kg.[6] However in the case of infant formula and follow-on formula as defined by Directive 91/321/EEC[7] or products containing processed cereal-based foods and baby foods for infants and young children as defined by Directive 96/5/EC,[8] the SML is lowered to 30 mg/kg. This is because babies have higher ratio of food consumption per body weight.

Toxicity

The tolerable daily intake (TDI) of ESBO defined by the Scientific Committee on Food (SCF) of the EU is 1 mg/kg body weight. This value is based on a toxicological assessment performed by the British Industrial Biological Research Association (BIBRA) in the late 1997. Repearted oral administration had been shown to affect the liver, kidney, testis and uterus of rats.[9] According to the conventional European rules for food packaging materials, the TDI became a basis for the SML of 60 mg/kg.

See also

References

  1. 1 2 3 4 MSDS for ESBO, Arkema Inc.
  2. 1 2 Guenter Sienel; Robert Rieth; Kenneth T. Rowbottom (2005), "Epoxides", Ullmann's Encyclopedia of Industrial Chemistry, Weinheim: Wiley-VCH, doi:10.1002/14356007.a09_531
  3. ↑ Holser, Ronald A. (2008). "Transesterification of epoxidized soybean oil to prepare epoxy methyl esters". Industrial Crops and Products. 27: 130–132. doi:10.1016/j.indcrop.2007.06.001.
  4. ↑ Pedersen, G. A.; Jensen, L. K.; Fankhauser, A.; Biedermann, S.; Petersen, J. H.; Fabech, B. (2008). "Migration of epoxidized soybean oil (ESBO) and phthalates from twist closures into food and enforcement of the overall migration limit". Food Additives & Contaminants: Part A. 25 (4): 503–510. doi:10.1080/02652030701519088.
  5. ↑ Fankhauser-Noti, Anja; Biedermann-Brem, Sandra; Grob, Koni (2006). "PVC plasticizers/additives migrating from the gaskets of metal closures into oily food: Swiss market survey June 2005". European Food Research and Technology. 223 (4): 447–453. doi:10.1007/s00217-005-0223-7.
  6. 1 2 EC.europa.eu RAPID ALERT SYSTEM FOR FOOD AND FEED
  7. ↑ Commission Directive 91/321/EEC of 14 May 1991 on infant formulae and follow-on formulae, Faolex.fao.org
  8. ↑ COMMISSION DIRECTIVE 96/5/EC of 16 February 1996 on processed cereal-based foods and baby foods for infants and young children, Idace.org
  9. ↑ Epoxidised soya bean oil, Bibra-information.co.uk
This article is issued from Wikipedia - version of the 12/2/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.