Beta attenuation monitoring

The schematic of a beta attenuation monitor (BAM). The detector allows to assess cumulative mass concentration of suspended particulate matter (PM) in the ambient air. Notation: 1 – air inlet; 2 – cycling ribbon; 3 and 4 – beta radiation sources; D1 and D2 – beta radiation detectors; 5 – air pump; 6 – air exhaust.

Beta attenuation monitoring (BAM) is a widely used air monitoring technique employing the absorption of beta radiation by solid particles extracted from air flow. This technique allows for the detection of PM10 and PM2.5, which are monitored as standards by most air pollution regulatory agencies. The main principle is based on a kind of Bouguer (Lambert–Beer) law: the amount by which the flow of beta radiation (electrons) is attenuated by a solid matter is exponentially dependent on its mass and not on any other feature (such as density, chemical composition or some optical or electrical properties) of this matter.[1] So, the air is drawn from outside of the detector through an "infinite" (cycling) ribbon made from some filtering material so that the particles are collected on it. There are two sources of beta radiation placed one before and one after the region where air flow passes through the ribbon leaving particles on it; and there are also two detectors on the opposite side of the ribbon, facing the detectors. The sources' intensity and detectors' sensitivity being the same (or corrected with appropriate calibration lookup table), the intensity of beta rays detected by one of detectors is compared to that of the other. Thus one can deduce how much mass has the ribbon acquired upon being exposed to air flow; knowing the drain velocity, actual particle mass concentration in air could be assessed.

The radiation source can be a gas chamber, filled with 86Kr gas, or a pieces of 14C-rich polymer plastic, such as PMMA.[2][3] Detector is simply a Geiger–Mueller counter. The particulate matter content measured is affected by the moisture content in the air, unfortunately.[4]

To discriminate between particle of different sizes (e. g., between PM10 and PM2.5), some preliminary separation could be accomplished, for example, by cyclone battery.

A similar method exists, where instead of beta particle flow an X-ray Fluorescence Spectroscopic monitoring is applied on the either side of air flow contact with the ribbon. This allows to obtain not only cumulative measurement of particle mass, but also to detect their average chemical composition (technique works for potassium and elements heavier than it).[5]

References

  1. ↑ A. Liberti. Modern Methods for Air Pollution Monitoring. Pure and Applied Chemistry 1975, 44(3). – pp. 519–534.
  2. ↑ Compendium of Methods for the Determination of Inorganic Compounds in Ambient Air. Chapter IO-1. Continuous measurement of PM10 suspended particulate matter (SPM) in ambient air. EPA:Cincinnati, 1999. – 7 p.
  3. ↑ Enviro Technology Services. Product overview: OPSIS SM200 PM10 PM2.5 Sampler. Online: http://www.et.co.uk/products/air-quality-monitoring.
  4. ↑ UK Equivalence Programme for Monitoring of Particulate Matter. Final report. Bureau Veritas: London, 2006. – 126 p.
  5. ↑ Enviro Technology Services. Product overview: CES Xact 625 Monitoring System. Online: http://www.et.co.uk/products/air-quality-monitoring.

Literature

This article is issued from Wikipedia - version of the 12/15/2014. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.