Anti-tank grenade

Diagram of a Soviet RPG-43 antitank grenade

An anti-tank grenade is a specialized explosive device used to defeat heavily armored targets. Although their inherently short range limits the usefulness of grenades, troops can lie in ambush or manoeuvre under cover to exploit the limited outward visibility of the crew in a target vehicle.

History

The first anti-tank grenades were improvised devices. During World War I the Germans were the first to come up with an improvised anti-tank grenade, taking their regular stick grenade and taping two to three more of the explosive heads without the sticks to create one larger grenade. In combat, after arming, the grenade was thrown on top of the slowly advancing tank where the armor was thin. The destructive properties of the stick grenade relied on its explosive payload, rather than the fragmentation effect, which was advantageous against hard targets.

During World War II, various nations made improvised anti-tank grenades by putting a number of defensive high explosive grenades into a sandbag. Due to their weight, these were normally thrown from very close range or directly placed in vulnerable spots onto an enemy vehicle. Another method used by the British Home Guard in 1940 was to place dynamite or some other high explosive in a thick sock and cover the lower part with axle grease and then place the grease covered part in a suitable size tin can. The sock was pulled out, the fuse lit and the sock thrown against the side of the tank turret in the hope it would stick until the explosion. If successful, it caused internal spalling of the armor plate, killing or injuring the tank crew inside.[1] It is not known if this type of improvised anti-tank grenade was ever successfully employed in combat. By late 1940, the British had brought into production a purpose-built adhesive anti-tank grenade - known as the "Sticky bomb"[2] - that was not very successful in combat.

When tanks overran entrenchments, hand grenades could be, and were, used by infantry as improvised anti-tank mines by placing or throwing them in the path of a tank in the hope of disabling a track. While this method was used in desperation, it usually proved more dangerous to the soldier on the ground than to the crew of the tank.

Chinese suicide bomber putting on an explosive vest made out of Model 24 hand grenades to use in an attack on Japanese tanks at the Battle of Taierzhuang.

Chinese troops in the Second Sino-Japanese War used suicide bombing against Japanese tanks. Chinese troops strapped explosives like grenade packs or dynamite to their bodies and threw themselves under Japanese tanks to blow them up.[3] This tactic was used during the Battle of Shanghai, where a Chinese suicide bomber stopped a Japanese tank column by exploding himself beneath the lead tank,[4] and at the Battle of Taierzhuang where dynamite and grenades were strapped on by Chinese troops who rushed at Japanese tanks and blew themselves up.[5][6][7][8][9][10] During one incident at Taierzhuang, Chinese suicide bombers obliterated four Japanese tanks with grenade bundles.[11][12]

Purpose-designed anti-tank grenades generally use the shaped charge principle to penetrate tank armor, although the squash head concept is also used. In military terminology, warheads employing shape charges are called High Explosive Anti-Tank (HEAT) warheads. Because of the way shaped charges function, the grenade must hit the vehicle at an exact right angle for the effect to work most efficiently. The grenade facilitates this by deploying a small drogue parachute or fabric streamers after being thrown.

Britain put the first purpose-built anti-tank grenade into the field during the Second World War in late 1940 with the No 68 AT Grenade, which was one of the first "any" type anti-tank weapons of the shape charge or HEAT type. The No 68 was fired from a rifle using the Mills grenade cup launcher. The Type 68 had a penetration of 50 mm of armor plating, which was astonishing for 1940. Also developed by the UK during the war was the No 74 ST Grenade, popularly known as the "sticky bomb", in which the main charge was held in a glass sphere covered in adhesive. In anticipation of a German invasion, the British Army asked for ideas for a simple, easy to use, ready for production and cheap close-in antitank weapon. The ST Grenade was a government sponsored initiative, by MIR(c), a group tasked with developing weapons for use in German and Italian occupied territory, and they placed the ST Grenade into mass production at Churchill's insistence, but seeing how it was operated, the British Army rejected it for the Home Guard much less their regular forces.

The No 74 Grenade was later issued to troops as an emergency stop-gap measure against lightly armored Italian tanks in North Africa, where it provedto the surprise of manyhighly effective. Later in the war, French partisans used the No 74 effectively in sabotage work against German installations.[13] The Hawkins grenade (No 75) was yet another anti-tank grenade that could be thrown or strung together in a chain and employed in a road-block.

Shortly after the German invasion of Russia in 1941, the Germans introduced the Panzerwurfmine(L), an extremely lethal close-quarter HEAT anti-tank grenade that could destroy the heaviest armored tanks in the war. The grenade was tossed overhand to land atop the tank. After release by the thrower, three spring-out canvas fins stabilized it during its short flight. The Panzerwurfmine(L) was lethal, and inexpensive to manufacture, but required considerable skill to throw accurately and was issued only to specially trained infantry tank-killer teams.[14]

It did not take long after the Russians captured the German Panzerwurfmine(L) to come out with their own hand-thrown anti-tank grenade with a HEAT warhead. In 1940, they developed a crude anti-tank grenade that used the simple blast effect of a large high explosive charge, designated RPG-40, which was stabilized in flight by a ribbon released after it was thrown.[15] The RPG-43 (developed in late 1943) was a modified RPG-40 with a cone liner and a large number of fabric ribbons for flight stabilization after release. In the last year of the war, they introduced the RPG-6, a total redesign of the RPG-43 with an improved kite-tail drogue in the handle and a standoff for the HEAT warhead, drastically increasing both accuracy and penetration, which was reported to be over 100 mm, more than adequate to cause catastrophic damage to any tank if it impacted the top. The Russian RPG-43 and RPG-6 were far simpler to use in combat than the German Panzerwurfmine(L) and did not require extensive training.

After the end of World War Two, many eastern European nations engineered their own versions of the RPG-6, such as the Hungarian AZ-58-K-100. These were manufactured in the tens of thousands and given to 'armies of national liberation', seeing combat worldwide, including with the Egyptian Army during 1967 and 1973.[16][17][18]

The first Japanese anti-tank grenade was a hand-thrown grenade, which had a simple 100 mm diameter cone HEAT warhead with a simple "all the way" fuse system in the base. (If dropped accidentally with the pin removed, it would explode). It had what looked like the end of a mop head on the tail end of the warhead. A soldier would remove the antitank grenade from its sack, pull the pin, and throw it gripping the mop-head as the handle. This was dangerous, as there was no arming safety after release and the thrower could strike something in his back swing before release. Penetration was reportedly only around 50 mm.

The second Japanese anti-tank grenadea suicide weaponwas nicknamed the 'lunge mine'.[19] This weapon was a very large HEAT warhead on a five-foot stick. The soldier rammed it forward into the tank or other target, which broke a shear wire that allowed a strike pin to impact a primer and detonate the large HEAT warheaddestroying both soldier and target.[19] While crude, the Japanese lunge mine had six inches (150 mm) of penetration, the greatest penetration of any anti-tank grenades of World War Two.

The U.S. Army first encountered the hand-thrown anti-tank grenade in 1944, in the Philippines (some believe they were locally manufactured). The later suicide 'lunge mine' first appeared during the U.S. invasion of Saipan and the subsequent invasion of Okinawa. Tens of thousands of these crude devices were produced and issued to both regular units and home-guard units on the home islands of Japan before the war ended.[20]

External images
US Army Early 1980s HAG Concept
Details of HAG concept (US Army)
Details of Combat Use of HAG (US Army)

In the late 1970s, the U.S. Army was worried about the lack of emergency anti-tank weapons for issue to its rear area units, to counter isolated enemy armored vehicles infiltrating or being air dropped. When the US Army asked for ideas, engineers at U.S. Army laboratories suggested the reverse-engineered and additional safety improvements of the East German AZ-58-K-100 HEAT anti-tank grenade that had been clandestinely obtained. This concept was called "HAG" for "High-explosive Antiarmor Grenade". While the civilian engineers working for the US Army thought it was a great idea, it was rejected out of hand by almost all senior US Army officers with field experience, who thought it would be more dangerous to the troops who used them than the enemy. The idea was quietly shelved by 1985.[21] This decision left many rear-area U.S. units with no heavier "anti-tank weapon" than the M2 heavy machine gun.

The most widely distributed anti-tank grenades today are the post World War Two Russian designs of the 1950s and 1960s, mainly the RKG-3.

During the Iran–Iraq War the Iranian Mohammad Hossein Fahmideh blew himself up under an Iraqi tank with a grenade.

Due to improvements in modern tank armor, anti-tank hand grenades are generally considered obsolete. However, in the recent Iraq War, the RKG-3 anti-tank hand grenade has made a reappearance with Iraqi insurgents who used them primarily against U.S. Humvees, Strykers and MRAPs, which lack the heavier armor of tanks. This has in turn led the U.S. to adopt countermeasures such as modifications to MRAP and Stryker vehicles by the fitting of slat armor, which causes the anti-tank grenade to detonate before coming in contact with the vehicle.[22]

References

  1. A 1941 issue of LIFE magazine showed a series of photo on how to make such antitank grenades along with X shaped slit trenches to protect the grenade thrower
  2. Ian Hogg "Grenades & Mortars" page 38 Ballantine Books 1974
  3. Schaedler, Luc (2007). Angry Monk: Reflections on Tibet: Literary, Historical, and Oral Sources for a Documentary Film (PDF) (Thesis Presented to the Faculty of Arts of the University of Zurich For the Degree of Doctor of Philosophy). University of Zurich, Faculty of Arts. p. 518. Archived from the original (PDF) on 10 June 2015. Retrieved 24 April 2014.
  4. Harmsen, Peter (2013). Shanghai 1937: Stalingrad on the Yangtze (illustrated ed.). Casemate. p. 112. ISBN 161200167X. Retrieved 24 April 2014.
  5. "Chinese Tank Forces and Battles before 1949, Chapter One: PLA Tank Forces In Its Infancy". TANKS! e-Magazine (#4). Summer 2001. Archived from the original on 7 August 2014. Retrieved 2 August 2014.
  6. Xin Hui (8 January 2002). "Xinhui Presents: Chinese Tank Forces and Battles before 1949". Newsletter 1-8-2002 Articles. Archived from the original on 8 August 2014. Retrieved 2 August 2014.
  7. Ong, Siew Chey (2005). China Condensed: 5000 Years of History & Culture (illustrated ed.). Marshall Cavendish. p. 94. ISBN 9812610677. Retrieved 24 April 2014.
  8. Olsen, Lance (2012). Taierzhuang 1938 – Stalingrad 1942. Numistamp. Clear Mind Publishing. ISBN 978-0-9838435-9-7. Retrieved 24 April 2014.
  9. "STORM OVER TAIERZHUANG 1938 PLAYER'S AID SHEET" (PDF). grognard.com. Retrieved 24 April 2014.
  10. Dr Ong Siew Chey (2011). China Condensed: 5,000 Years of History & Culture (reprint ed.). Marshall Cavendish International Asia Pte Ltd. p. 79. ISBN 9814312991. Retrieved April 24, 2014.
  11. International Press Correspondence, Volume 18. Richard Neumann. 1938. p. 447. Retrieved 24 April 2014.
  12. Epstein, Israel (1939). The people's war. V. Gollancz. p. 172. Retrieved 24 April 2014.
  13. Ian Hogg "Grenades & Mortars" page 39 Ballantine Books 1974
  14. Chris Bishop "Weapons of World War II" page 207-208 Barnes and Nobles Books 1998
  15. Denis H.R. Archer "Jane's Infantry Weapons" page 462
  16. Chris Bishop "Weapons of World War II" page 214 Barnes and Nobles Books 1998
  17. Denis H.R. Archer "Jane's Infantry Weapons" page 464-465
  18. Note - see the External Images on the HAG in the "Anti-tank" section of this article for a detail drawings and how Russian anti-tank grenades operate
  19. 1 2 O'Neill, Richard (1981). Suicide Squads: Axis and Allied Special Attack Weapons of World War II: their Development and their Missions. London: Salamander Books. p. 296. ISBN 0 861 01098 1.
  20. edited by W.H. Tantum and E.J. Hoffschmidt "Second World War COMBAT WEAPONS - JAPANESE" page 174 and 184
  21. Eric C. Ludvigsen "Association of the United States Army GREEN BOOK 1984-85" page 348
  22. Schogol, Jeff (October 20, 2009) "MRAPs modified to deflect RKG-3 anti-tank grenades" Archived October 24, 2009, at the Wayback Machine.. Stars and Stripes (newspaper)

Category:German inventions

This article is issued from Wikipedia - version of the 11/17/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.